Frx4000 Protocol Parameters - Cabletron Systems Netlink FRX4000 User Manual

FRX4000 Protocol Parameters

Configuring Cards and Protocols
To add or remove a protocol, press the letter corresponding to the protocol number.
The protocol in the
Configured
(See Table 5-1.)
After all desired changes have been made, press
the FRX40004 as follows:
Rebooting will clear all connections on this device. However, the
device must be rebooted to implement the change.
1. Press .
[F10]
2. When asked:
Reboot the Node?
3. Type
restart [Enter]
Table 5-1 FRX4000 Protocol Parameters
Parameter
Protocol "n"
T1 LIC Parameters
Line Coding
Framing
Line Service
Line Build Out
Clocking
Base Chl Speed
Starting Chl Number
Num of Chnls
E1 LIC Parameters
Line Coding
Framing
Line Service
Line Build Out
Clocking
Base Chl Speed
Starting Chl Number
continued on next page
column will change to the next valid one.
, press .
[Y]
.
Valid Values
None, X.25, FR (frame relay), Async,
SDLC, BSC-I, BSC-B, IP, SNMP, RIP,
LLC2, IPX, NVSP (NetView Service
1
Point), BRIDGE
B8ZS/AMI
ESF, D4
Full, Fractional
2
see footnote
Master, Slave
56K, 64K
If =
Line Service Fractional: 1–24
f =
I Line Service Full: n/a
If =
Line Service Fractional: 1–24
f =
I Line Service Full: n/a
HDB3
G.704
Full, Fractional
G.703
Master, Slave
64K
If =
Line Service Fractional: 1–30
f =
I Line Service Full: n/a
to save the changes, then reboot
[F3]
Default Value
next in list not
already configured
B8ZS
ESF
Full
0–133 ft. (0 dB)
Slave
64K
(only if
1
=
vice Fractional)
(only if
24
=
vice Fractional)
HDB3
G.704
Full
G.703
Slave
64K
(only if
1
=
vice Fractional)
Line Ser-
Line Ser-
Line Ser-
5-3