Dial Port Parameters - Cabletron Systems Netlink FRX4000 User Manual

Preferential CUG
Incoming Access Allowed
Outgoing Access Allowed

Dial Port Parameters

Dial Support
Inactivity Timer
Disconnect Timer
Line Setup Timer
Configuring X.25
is a default CUG for the port. Any calls that do not specify a CUG will default to this
one if
Preferential CUG Flag
determines whether this port will be allowed to receive calls from outside its CUGs.
determines whether this port will be allowed to make calls outside its CUGs.
Parameter
Dial Support
(minutes)
Inactivity Timer
(seconds)
Disconnect Timer
(seconds)
Line Setup Timer
specifies whether this port is connected to a dial modem and, if so, whether connec-
tions will be initiated through dial-in or dial-out calls. (Signaling differences prevent
configuration for both dial-in and dial-out on the same port.)
A dial-out port will establish a link only when an outgoing X.25 call is placed, at
which time the port will raise DTR and the attached modem will dial a stored number
to a remote modem to establish an X.25 connection. A dial-in port will establish a link
only when a call is received.
If this port is configured as a network trunk, the value for
will be started as soon as there are no active connections on a dial port. (It has no
function on a non-dial port.) If no new connections are established before the period
expires, the port will be disabled until the next call is placed, if a dial-out port, or the
expires (see next entry), if a dial-in port.
Disconnect Timer
is the length of time a dial-in port will remain disabled after expiration of the Inactivity
Timer.
is started when the port enters
response from the other end, the port will enter
is . A new port has CUG
Y
Table 8-3 X.25 Port Dial Parameters
Valid Values
None, Dialout, Dialin
1–30
1–255
1–255
state. If the timer expires before there is a
Linkup
specified here.
0
Default Value
None
5
5
5
Dial Support
state.
Failed
must be .
None
8-13