Bridge Sap Filter Parameters; Bridge Protocol Filter Parameters - Cabletron Systems Netlink FRX4000 User Manual

Filter Name
Source MAC Address Value
Destination MAC Address Value
Filter Name
SSAP Value
DSAP Value
Filter Name
Protocol ID Value
Configuring Bridging
helps the user identify the filter. The name is not used by the software.
is the MAC address in the source address field of the frame.
is the MAC address in the destination address field of the frame.
Table 15-4 Bridge SAP Filter Parameters
Parameter
Filter Name
SSAP Value
SSAP Mask
DSAP Value
DSAP Mask
helps the user identify the filter. The name is not used by the software.
identifies the source Service Advertising Protocol (SAP).
identifies the destination SAP.
Table 15-5 Bridge Protocol Filter Parameters
Parameter
Filter Name
Protocol ID Value
Protocol ID Mask
helps the user identify the filter. The name is not used by the software.
is the IEEE 802 value of the protocol (SNAP or Type II) to which the filter will apply.
Valid Values
1–31 characters
(1 byte)
0–ff
0–ff
0–ff (1 byte)
0–ff
Valid Values
1–31 characters
0–ffff (2 bytes)
0–ffff (2 bytes)
Default Value
none
0
0
0
0
Default Value
none
0000
0000
15-9