Node Defaults Parameters - Cabletron Systems Netlink FRX4000 User Manual

Node Defaults Parameters

Node Name
Configuring Node-Wide Default Parameters
All possible parameters on the first two Node Defaults screens are listed in Table 4-1,
and the NetView parameters on the third screen are listed in
of most parameters follow each table.
Parameter
Node Name
Remote Control ID
Remote Control Pwd
File Transfer ID
File Transfer Pwd
Collecting Node ID
Collecting Node Pwd
Primary Alarm Output ID
Primary Alarm Output Pwd
Secondary Alarm Output ID
Secondary Alarm Output Pwd
Com. Port Thruput
Com. Port Parity:
Com. Port Stopbit
Bits per Character
Collecting Node
Max Congestion
Min Congestion
Periodic Status Timer
Line Idle Timer
Alarm Autocall Timer
Alarm Max Retries
Footnotes for Table 4-1:
Remember that the software sees uppercase as different from lowercase.
1
Can be:
2
a 1–15 digit number (address).
(FRX6000 only) a COM port:
(FRX6000 only) a parallel (LPT) port:
A value of means that no status will be sent.
0
3
If , the connection will remain active continuously.
0
4
Continuous retries until connection is established.
5
is displayed at the upper right of the screen when the device is being controlled by the
"local" keyboard and monitor. (If the local operator is controlling a remote FRX4000/
Table 4-1 Node Defaults Parameters
Valid Values
up to 8 characters
0–15 digits
0–15 characters
0–15 digits
0–15 characters
0–15 digits
0–15 characters
see footnote
0–15 characters
see footnote
0–15 characters
A–H
0, 1, 3
1, 2
7, 8
Y/N
(%)
1–50
1–50 (%)
(min)
0–30
0–65535
5–3600
0–99
or , plus
C1 C2
P1, P2, P3.
Table 4-2. Descriptions
Default Value
none
none
1
remote
none
1
ftran
none
1
alarms
2
none
1
alarms
2
none
1
alarms
(9600 bps)
H
0 (none)
1
8
N
50
25
3
1
4
(sec)
0
(sec)
60
(no max)
0
or if those ports exist.
C3 C4
5
4-3