Displaying Port Signals; Port Signals Display - Cabletron Systems Netlink FRX4000 User Manual

Displaying Port Signals

Information in this Display
19-6
This display lists basic configuration and line status for all serial ports on a specified
RLP, as well as signal states (on/off) at the physical interfaces.
Press at the Status Displays Menu and, when prompted, enter an RLP number:
[D]
. The display will show the first four ports, and pressing
7
four ports.
Line Processor Status RLP: 0
Port Number:
Phy Interface:
Port Config:
Logical Inter:
Line Speed: 1.008M
Line Status:
TD(2)
RD(3)
RTS(4)
CTS(5)
DSR(6)
DCD(8)
TC(15)
RC(17)
DTR(20)
F2:Next RLP CardF9:Stop RemoteF10:Abort Remote
PgUp:First 4 PortsPgDn:Last 4 PortsOthers:Exit08:14:52
– is self-explanatory.
Port Number
– is the type of connector on the port. On an FRX6000, this is the
Phy Interface
connector on the I/O cable exiting the port's I/O box connector toward the sub-
scriber device. (This information is taken from the Port record.)
– is the port type (
Port Config
record. If no record has been created for this port,
line and the one below it.
– is the logical interface,
Logical Inter
If no record has been created for this port,
the one above it.
– is the speed configured in the Port record.
Line Speed
:
Line Status Failed
Disconnect
Restart
Not_configured
Operational
Interface: RS-422
0 1 2
X.21 RS-449
FR No SNA
DTE Config DCE
1.472M
Oper Oper
ON ON
OFF ON
OFF ON
OFF ON
ON ON
ON ON
ON ON
ON ON
ON ON
Figure 19-5 Port Signals Display
,
FRL SNA
DCE
(level 2 is down)
(level 2 is up; level 3 is down)
(level 3 is restarting)
(port is not configured)
(level 3 is up)
will display the other
[PgDn]
Node Name=node_xyz
3
X.21
FR
DCE
2.048M
Oper
ON
ON
ON
ON
ON
ON
ON
ON
ON \
[C],[D] from Main Menu
, , etc.) as configured in the Port
X25
is displayed on this
No Config
or , as taken from the Port record.
DTE
is displayed on this line and
No Config
FRX4000/FRX6000 4.0 User Guide, Rev 01
0–