Ethernet/Token Ring Ip Interface Parameters - Cabletron Systems Netlink FRX4000 User Manual
Frame relay access products
Hide thumbs
Also See for Netlink FRX4000:
- Maintenance manual (60 pages) ,
- Installation and setup manual (8 pages) ,
- User manual (420 pages)
Table of Contents
Advertisement
13-10
Table 13-4 Ethernet/Token Ring IP Interface Parameters
Parameter
Maximum Transmission Unit
Routing Metric Count
ICMP Redirects
RIP Support
(sec)
RIP Flash Updates
RIP Full Updates
(sec)
Priority
Bandwidth Allocation Group
Interface Type
Source IP Address
Network Mask
Broadcast Address
LAN Card Number
Proxy ARP Enabled
Secondary Address Parameters
Seq
Sec. IP Addr
NetMask
Bcast Addr
RMetric
RIP Support
The default value of the network mask will be configured automatically, to reflect the
1
appropriate address class, after an IP address is specified. (
by
Source IP Address
configured as unnumbered (and, therefore, no
default value of
Network Mask
assigned.
If an IP address (
changed, the network mask will automatically change to
default values appropriate for the new address. For this
reason, configure the IP address first, then the mask.
The default value of the broadcast address will be configured automatically after an IP
2
address or a network mask is specified. The value will be the dotted decimal notation
result of "ANDing" the binary versions of the IP address and the network mask, then
filling in the remaining bits with
and
Address
Network Mask
.)
NetMask
If the (
Source IP Address/Sec. IP Addr
is specified/changed, the associated broadcast address
will automatically change to default values appropriate
for the new address. For this reason, configure the IP
address first, then the mask, then the broadcast address.
Valid Values
1–4096
0–255
Y/N
0
(Enabled),
1
(Rcv only),
(Disabled)
2
5–300
10–300
0–9
1–16
Ethernet, 802.3, 802.5
1.0.0.0–223.255.255.255
1.0.0.0–223.255.255.255
1.0.0.0–223.255.255.255
FRX4000:
0
FRX6000:
0–1
Y/N
1–15
1.0.0.0–223.255.255.255
1.0.0.0–223.255.255.255
1.0.0.0–223.255.255.255
0–255
Enabled, Rcv Only, Disabled
, and
is determined by
NetMask
Source IP Address
will be taken from the numbered interface that is
Source IP Address/Sec. IP Addr
s. (
1
Broadcast Address
, while
is associated with
Bcast Addr
FRX4000/FRX6000 4.0 User Guide, Rev 01
Default Value
1500
0
Y
(Enabled)
0
10
30
5
1
n/a
none
1
see note
2
see note
0
N
next in sequence
none
1
see note
2
see note
0
Enabled
is determined
Network Mask
.) If the interface is
Sec. IP Addr
is configured), the
) is specified/
is associated with
Source IP
and
Sec. IP Addr
) or
Network Mask/Netmask
Advertisement
Table of Contents
