Cabletron Systems Netlink FRX4000 User Manual page 382

– is a response to an invalid command.
ERR
– indicates a network congestion error.
ERR NC
– indicates that the port is not finding the stop bit at the end of the
FRAMING ERROR
character bits. This can be due to noise or a mismatch in such parameters as speed,
bits/character, or stop bits between the port and its connected device.
– indicates that modem signals on the port were dropped to
LINE DISCONNECTED
effect a physical disconnection.
– is a request to enter a subscriber ID.
login
– indicates that login was successful and the user is now connected to the
LOGIN ACC
network.
– indicates that login was unsuccessful.
LOGIN REJ
– is displayed when the PAD accepts a logout command.
LOGOUT ACC
– is displayed when the user attempts to log out, but either the Port
LOGOUT REJ
record was not configured to require login, or a VC on this port has not yet been
cleared.
– indicates that the PAD is unable to cope with the rate at which
OVERRUN ERROR
characters are being received by the port, resulting in loss of characters. Enabling
XON-XOFF flow control (async PAD profile parameter 5) usually corrects this error.
– indicates that a "page wait" condition (async PAD profile parameter 22) has
PAGE
occurred.
– indicates a parity error on the port, due to either noise on the channel
PARITY ERROR
or an incompatibility between the parity settings of the port and its connected device.
– is a request to enter a password.
password
– means the async PAD profile was accepted.
PROF ACC
– means the async PAD profile was rejected.
PROF REJ
– indicates that a was received on a PVC port, suggesting a possible
PVC ERR Clear
abnormality in the port configuration.
– indicates a received from the network.
RESET Reset
– means that the network has received a from the remote DTE.
RESET DTE Reset
– means was not allowed.
SET CMD DISALLOWED Set Command
– is a response to the command, indicating that a VC is cur-
STAT ENGAGED Status
rently set up on the port.
– is a response to the command, indicating that no VC is currently
STAT FREE Status
set up on the port.
– indicates a called DTE reselection by the PAD to
TRANSFER "nnnn" COM "nnnn."
A-4 FRX4000/FRX6000 4.0 User Guide, Rev 01