Warning Messages - Cabletron Systems Netlink FRX4000 User Manual
Frame relay access products
Hide thumbs
Also See for Netlink FRX4000:
- Maintenance manual (60 pages) ,
- Installation and setup manual (8 pages) ,
- User manual (420 pages)
Table of Contents
Advertisement
Warning Messages
Primary Alarm Reporting Error
Primary NOT Configured
Primary/Secondary C/P"n" NOT installed
Primary/Secondary Printer/Connection Problem
Primary/Secondary C/P"n" NOT Initialized
Errmsg.txt Database Error
4-10
These messages may be displayed on some screens if there is a problem with the con-
figuration for alarm reporting.
will appear at the top of all screens on a collecting node if the software that drives the
alarm output device is unable to output to the device.
will be displayed at the bottom of both Node Defaults screens if a
is not specified.
Output ID
will be displayed at the bottom of both Node Defaults screens if a serial (
(
) port is specified for the
P
the port is either incorrectly configured or is not installed. For a serial port, this
message will also be displayed if the card is properly installed but the device at the
other end is not.
will be displayed at the bottom of both screens if a parallel (
card containing the port is installed but the device at the other end is not. Note that this
will not be determined by the software until the first alarm is sent to the parallel port.
will be displayed at the bottom of all both screens if a serial or parallel port is spec-
ified, but either the software cannot find the specified port or it is in use for some other
purpose.
will be displayed if the file ERRMSG.TXT can not be found. (This may happen if a
software update was not correctly installed.) To correct this on an FRX4000, the file
can be transferred from a remote FRX4000/6000 or copied from a locally attached PC
(with Procomm), as described on
with the following procedure:
1. Press
at the Main Menu.
[F10]
2. When asked:
Reboot the Netlink FRX6000?
3. As the node starts to boot, press
4. When asked:
Terminate batch job?
5. At the DOS prompt, type
6. To restart the FRX6000, type
Primary/Secondary Alarm Output ID
page
18-10. On an FRX6000, the file can be created
, press
.
[Ctrl] [C]
, press
.
[Y]
.
generr.exe [Enter]
.
omni4 [Enter]
Primary Alarm
C
, but the card containing
) port is specified and the
P
.
[Y]
FRX4000/FRX6000 4.0 User Guide, Rev 01
) or parallel
Advertisement
Table of Contents
