Table of Contents
Advertisement
1.3
WPIM-DDS FEATURES
The WPIM-DDS extends the functionality of the Wide Area Network
module to allow remote connectivity using Digital Data Service (DDS).
The WPIM-DDS provides a DDS interface that includes a built-in
Channel Service Unit/Digital Service Unit (CSU/DSU) for direct
connection to a DDS line.
Diagnostic Loopback
The WPIM-DDS supports remote CSU diagnostic loopback and
Non-Latching remote DSU diagnostic loopback.
WAN Protocols
As of this printing, the module in which the WPIM-DDS is installed
supports the following WAN protocols (refer to the Release Notes
included with the host MIM or standalone hub for a list of current
protocols):
•
Point to Point Protocol (LCP) as defined by RFC 1661
•
Point to Point Protocol (BNCP) as defined by RFC 1638
•
Point to Point Protocol LAN Extender (PPP/LEX)
•
Frame Relay as defined by RFC 1490
MIB Support
Refer to the Release Notes included with the host MIM or standalone hub
for a list of all MIBs supported by the WPIM-DDS. For information about
how to extract and compile individual MIBs, contact Cabletron Systems
Technical Support (refer to the section Getting Help in this chapter).
1.4
WPIM-DDS PORT ASSIGNMENT
The WPIM-DDS features one RJ45 port to enable any Cabletron product
supporting the WPIM architecture to connect directly to a single Digital
Data Service (DDS) circuit. The pinout information for the port is shown
in Table 1-1, below. Table 1-2 lists the Cabletron Systems part number for
the interface cable for the WPIM-DDS.
WPIM-DDS Local Management Guide
WPIM-DDS Features
1-3
Advertisement
Table of Contents
