Subscriber Parameters - Cabletron Systems Netlink FRX4000 User Manual

NAK Retry Count
VC to be Cleared After Disc
Idle Timer

Subscriber Parameters

Sq
Local Sub
Remote Sub
Atcl
Rtytm
Rty#
Del
Configuring BSC Batch
specifies the number of times the node will send a frame when the receiving device is
unable to acknowledge; that is, returns a NAK to the node.
specifies whether the virtual circuit will be cleared after completion of a file transfer.
is activated on reception of an EOT from the line. On expiry, an EOT is sent to the line
and a Clear Request is sent if
is simply a line number to ease selection of a line on the screen to change. To move to
another line, press and enter the sequence number.
[A]
is the calling address used by the local device. A Subscriber ID (see
also be configured for this address.
is the called address used for calls by the local device. A Subscriber ID (see
8) must also be configured for this address.
If the BSC port is one end of a connection to a logical X.25 port in the FRX4000/6000,
this address must match a Subscriber ID configured for the logical port.
(Autocall) causes a BSC device to automatically the remote end when it becomes
active.
is the Retry Timer, which determines the time between autocall retries.
is the maximum number of times an autocall will be sent. Note that a value of
indefinite retries.
lets you delete the remote subscriber that is currently highlighted. You will be
prompted: where
Delete "n,"
line and move all entries below it up one sequence number.
VC to Be Cleared After Disc
is the sequence number. Pressing
"n"
is .
Y
page 11-8) must
page 11-
allows
0
will delete that
[Y]
11-7