Database And System Memory Values - Cabletron Systems Netlink FRX4000 User Manual

Database and System Memory Values

4-2
After making any changes, be sure to press
system memory. Otherwise, the changes will not take effect until
the next re-boot of the FRX4000/6000.
Although the entries for the various passwords appear blank,
default values exist; if you change one, be sure you do not
duplicate an existing password.
If there is a error in the configuration for alarm reporting, a message will
be displayed at the top or bottom of the screen. The possible messages are
described on
Primary Output ID
only) serial/parallel ports. If a serial port is specified, no associated
password (
Pwd
ating parameters (listed in
Two sets of values exist for Node Defaults parameters: Database values exist in the
software, and are recorded as System Memory values when the node is booted. If the
port type is the same in both sets of values, both sets will be displayed.
Any change you make will be recorded as a Database value, and will be copied to the
System Memory side only if you press
saved to the database until you press
page 4-10.
and
Secondary Output ID
) entry will be displayed for the ID. Instead, a group of oper-
Table 4-1) for the port will be displayed.
. Note that changes will not be actually be
[F7]
to exit the record.
[F3]
to update the
[F7]
can be addresses, or (FRX6000
FRX4000/FRX6000 4.0 User Guide, Rev 01