X.25 Ip Interface Parameters - Cabletron Systems Netlink FRX4000 User Manual
Frame relay access products
Hide thumbs
Also See for Netlink FRX4000:
- Maintenance manual (60 pages) ,
- Installation and setup manual (8 pages) ,
- User manual (420 pages)
Table of Contents
Advertisement
Configuring IP
Table 13-3 X.25 IP Interface Parameters
Parameter
Maximum Transmission Unit
Routing Metric Count
ICMP Redirects
RIP Support
(sec)
RIP Flash Updates
RIP Full Updates
(sec)
Priority
Bandwidth Allocation Group
Interface Type
Destination IP Address
Unnumbered Interface
Source IP Address
Network Mask
Source Subscriber
Destination Subscriber
(sec)
SVC Retry Timer
(min)
SVC Idle Timer
Max VCs to Establish
PVC Connection
for new interfaces, N for interfaces already configured when the current release of
Y
1
FRX4000/6000 software is installed.
is valid only on a point-to-point interface.
255.255.255.255
2
See the caution following these footnotes. The default value of
3
configured automatically, to reflect the appropriate address class, after the
Address
is specified.. If the interface is configured as unnumbered (and, therefore, no
Source IP Address
is configured), the default value of
the numbered interface that is assigned.
If a
Source IP Address
will automatically change to a default value appropriate
for the new address. For this reason, configure the
IP Address
These addresses must also be configured in Subscriber records (described in
4
and cannot contain wildcards. In the record for the Source Subscriber, do not configure
any Routing Path. In the record for the Destination Subscriber, configure
as the node, RLP, and X.25 port that will be used for the physical interface. (On an
Path
FRX6000, that RLP does not need to be the same one that has IP installed.)
Valid Values
1–4096
0–255
Y/N
0
(Enabled),
1
(Rcv only),
(Disabled)
2
5–300
10–300
0–9
1–16
X.25
1.0.0.0–223.255.255.255
Y/N
1.0.0.0–223.255.255.255
255.0.0.0–255.255.255.255
valid subscriber address
valid subscriber address
5–60
0–5
1–8
Y/N
is specified/changed, the
first, then the
Network Mask
Default Value
1500
0
Y
(Enabled)
0
10
30
5
1
n/a
none
1
see note
none
3
2
255.0.0.0
4
none
4
none
20
1
1
N
will be
Network Mask
Source IP
Network Mask
will be taken from
Network Mask
.
Chapter
1st Routing
Source
8),
13-9
Advertisement
Table of Contents
