Required Configuration; Configuring A Physical X.25 Port - Cabletron Systems Netlink FRX4000 User Manual

Required Configuration

Configuring a Physical X.25 Port

8-2
To run a physical port as X.25, make sure the following are properly configured:
Node parameters, which is general configuration that must be done no matter
which protocols will be run in the node. See Chapter 4.
RLPs that will contain the interface(s) to the user device(s), network, and/or
X.25 PVC, plus Line Interface Card(s) supporting the ports that will be the inter-
faces. See Chapter 5.
Protocol(s): X.25 and any others that will be transmitted over the network. See
Chapter 5.
X.25 port(s) (see below) that will connect to the user device(s), network, and/or
PVC(s).
Subscriber ID(s)
FRX4000/6000.
Before configuring a logical X.25 port, make sure these are properly configured:
Protocol(s) that will be transmitted over the logical port. See Chapter 5.
Physical frame relay port
and Chapter 7.
Once the necessary Node
parameters have been configured, press
from the Main Menu. When prompted, enter:
[A]
(FRX6000 only) RLP containing the port:
(RLP numbers are described in Chapter 5.)
Port (see port locations
The display for an existing port will show the configured parameter values, while the
display for a new port will show default database values (listed in tables on
and page 8-13.) The following figure is an example of an existing port.
(page 8-21), which identifiy user devices to each other and the
on which the logical port will reside. See Chapter 6
(Chapter 4), RLP (Chapter
at the Port Configuration Menu (or
[A]
in Chapter 6):
0–7
5), and Protocol (Chapter
. (The default is .)
0–7 0
. (The default is .)
0
FRX4000/FRX6000 4.0 User Guide, Rev 01
5)
[A], [C],
page 8-6