Configuring Subscriber Ids; Typical Svc Subscriber Screen - Cabletron Systems Netlink FRX4000 User Manual

Bandwidth Allocation Group
Suppress XIDs

Configuring Subscriber IDs

9-14
assigns the LLC2 host to one of sixteen groups whose parameters regulate bandwidth
usage. See "Configuring Bandwidth Allocation
prevents (if ) the FRX4000/6000 from returning an XID in response to a null XID.
Y
This might be desirable if the remote TPAD is not running PU 2.1. It should be noted
that even if an XID is sent, an SNRM (Set Normal Response Mode) immediately
follows, so the connection will be established.
This operation configures the called and calling addresses that will be used for con-
necting to an LLC2 host, or in X.25 call setup if SNA is being transported over the
frame relay link via a logical X.25 port. To complete the connection, the software must
recognize where the call is coming from (calling address) and where it is going (called
address).
To display a list of current Subscriber IDs (addresses), press
Routing Paths Menu (or
To add or change a Subscriber ID, press
Menu. When prompted, enter a Subscriber ID of up to 15 digits. (ID conventions are
described on page 8-22.)
SVC Subscriber Maintenance
* Subscriber ID
A Subscriber Name
B Routing Algorithm
C Systematic Redirection
D Redirect on Busy
E Redirect on Out of Order
F Connection Priority
G Routing Paths
H Redirection Addresses
Option:
Figure 9-4 Typical SVC Subscriber Screen
Pressing will display routing paths, which link the subscriber with one or more
[G]
ports. Pressing will display the addresses used for call redirection. (These
[H]
from the Main Menu).
[A], [D], [A]
at the Connections and Routing Paths
[B]
0100012345
sub1
0, Round Robin
N
N
N
0
Groups" on page 7-6.
at the Connections and
[A]
Node Name=nodexyz
[A],[D],[B] from Main Menu
FRX4000/FRX6000 4.0 User Guide, Rev 01