Async Terminal Commands; Placing A Call From An Async Terminal - Cabletron Systems Netlink FRX4000 User Manual

Async Terminal Commands

Placing a Call from an Async Terminal

A-2
The following commands can be entered in
type .)
help [Enter]
– Get connection status.
STAT
– Clear Connection.
CLR
– Reads value of 1 or more
PAR? n1,n2,n3
1st parameter, = 2nd, etc.). Standard parameters are
n2
SET? n1:m1,n2:m2,n3:m3
parameter, = new value).
m1
– Sets standard set of parameters. CCITT profile
PROF
– Reset connection.
RESET
– Send interrupt packet.
INT
SET n1:m1,n2:m2,n3:m3
1st parameter,
m1
– Provides more information.
HELP
– Same as
? HELP
[Gnn], [Z], [Y], [R], [N]
Request packets (unless they are specified in autocall Call Requests):
= CUG (nn is the CUG number)
[Gnn]
= Group Send
[Z]
= Priority
[Y]
= Reverse Charging
[R]
= NUI
[N]
– displays the RLP and port number to which you are connected, and the
Port
called and calling addresses.
One way to place a call is simply to enter the calling address (subscriber ID) of the
destination DTE. (There must be a
and/or facilities (in any combination) can be included, as described below.
To place a call using facilities and user data, enter the data in the format:
f,f,f-addressDdata or f, f, f-addressPdata
is the letter(s) representing the desired facility(s):
f
= CUG (nn is the CUG number)
Gnn
= Group Send
Z
= Priority
Y
= Reverse Charging
R
= NUI
N
– is the called address,
address
Command
– Sets and reads async PAD profile parameters (
– Sets one or more async PAD profile parameters (
= new value).
.
– Selection parameters; used to represent facilities in Call
Subscriber ID record
, where:
mode. (For a list of commands,
async PAD profile parameters
.
1–22
is available.
90
for that address.) User data
FRX4000/FRX6000 4.0 User Guide, Rev 01
( =
n1
= 1st
n1
=
n1