Configuring Bridge Ports; Bridge Ports Display - Cabletron Systems Netlink FRX4000 User Manual

Configuring Bridge Ports

15-12
A Bridge port is an FRX4000/6000 LAN interface or frame relay port that will operate
as a bridge connection to the LAN or WAN.
Press at the IP/LLC2/BRIDGE/IPX Interfaces Configuration Menu to display con-
[C]
figured Bridge ports.
Review Bridge Ports/LLC2 Interfaces
-------------------------------------------------------------------------------------------------------
Interface Number
-------------------------------------------------------------------------------------------------------
0
1
2
3
4
PgUp, PgDn, F3:Exit, F9:Stop Remote, F10:Abort
These interfaces can be used for either LLC2 or Bridging.
To configure an interface, press
uration Menu. When prompted for an
number to identify the interface):
If modifying an existing record, enter the interface number:
Do not configure more than one interface per DLCI on a
port.
If creating a new record, press
available sequential interface number.
The display depends on the interface; the following figure shows an example, and
Table 15-8 lists the parameters for all interface types.
Type RLP Port DLCI
Ethernet
Frame Relay 0 1 30
Frame Relay 0 1 31
Frame Relay 0 1 32
Frame Relay 0 1 33
Figure 15-4 Bridge Ports Display
at the IP/LLC2/BRIDGE/IPX Interfaces Config-
[D]
Interface Number
, which will automatically specify the next
[Enter]
Node Name=node_xyz
Format
Native LLC-2
8025_SRB
8025_SRB
8023_TB
from Main Menu
[A],[C],[E],[C]
(which is merely a sequential
.
0–95
FRX4000/FRX6000 4.0 User Guide, Rev 01