Configuring Ipx Filter Applications; Typical Ipx Filter Applications Record - Cabletron Systems Netlink FRX4000 User Manual

Configuring IPX Filter Applications

14-8
IPX Filter Applications determine how filters will be used at the interface. To review
existing applications, press
Menu (or
[A], [A], [E], [F], [C]
at the Configure Filter Definitions and Applications Menu. When prompted, enter:
[D]
Interface number:
:
Filter Category 0
: (inbound) or
Direction i
Any other requested information, referring to
IPX Filter Applications
* Interface Number
* Filter Category
* Direction
A Permit
B Filter Application 1
C Filter Application 2
D Filter Application 3
E Filter Application 4
F Filter Application 5
G Filter Application 6
H Filter Application 7
I Filter Application 8
J Filter Application 9
K Filter Application 10
2 Page 2
Option:
Figure 14-3 Typical IPX Filter Applications Record
Up to 100 filters can be configured, displayed over 9 "pages" (screens).
When finished configuring filter definitions and applications, perform an on-line
update to make the changes effective immediately. Press
and Applications Configuration Menu. The changes will be sent to the software
running on the RLPs.
at the Configure Filter Definitions and Applications
[C]
from the Main Menu). To configure an application, press
. (The default is
0–63 0
= RIP, = SAP, = Packet,
1 2
(outbound). (The default is
o
2
0 RIP
I–Inbound
Y
0
0
0
0
0
0
0
0
0
0
.) This identifies the virtual interface.
= RIP Router. (The default is
3
.)
o
Table 14-6.
[A],[A],[E],[F],[D] from Main Menu
at the Filter Definitions
[E]
FRX4000/FRX6000 4.0 User Guide, Rev 01
.)
0