Configuring Async Port Records; Async Pad Port Screen - Cabletron Systems Netlink FRX4000 User Manual

Configuring Async Port Records

12-8
Once the necessary Node, Line Processor, and protocol parameters have been con-
figured, press at the Port Configuration Menu (or
[A]
When prompted, enter:
(FRX6000 only) RLP containing the port:
(RLP numbers are described in Chapter 5.)
Port (see port locations
The display for an existing port will show the configured parameter values, while the
display for a new port will show default database values. (See
lowing figure is an example of an existing port.
Async PAD Port Parameters
* RLP: 0 Port: 0 Link State: Linkup
* I/O:–RS-232
A Port Type
B Physical Port Interface
C Blocked Port Flag
D X.3 Line Speed
E Initial Profile Name
F Login Required
G Parity
H DCE Cable Attached
I Mask Link Alarms
J X.25 Parameter Options
K Autocall Options
L Browse Profile
M Modem Signal Options
N Disconnect Options
O Async PAD Options
Option:
Figure 12-2 Async PAD Port Screen
If a record does not exist for the async PAD profile identified by
Profile Name
column.
Database
After making any changes, be sure to press
system memory. Otherwise, the changes will not take effect until
the next re-boot of the FRX4000/6000.
Pressing ,
[J], [K], [M] [N]
page 12-9). Pressing
[L]
in this chapter) that are resident in the FRX4000/6000 software.
in Chapter 6):
0–7
Database
Async PAD
RS-232
N
autobaud
90
N
0,none
N
N
, the letter will be displayed preceding the name in the
U
, or will display more parameters, listed in
[O]
will display the async PAD profile parameters (listed earlier
from the Main Menu.
[A], [C], [A]
. (The default is
0–7 0
. (The default is .)
0
Table 12-3.) The fol-
Node Name=nodexyz
System Memory
Async PAD
RS-232
N
autobaud
90
N
0,none
N
N
from Main Menu
[A],[C],[A]
to update the
[F7]
FRX4000/FRX6000 4.0 User Guide, Rev 01
.)
Initial
Table 12-3 (on