X.25 Port Screen 1 - Cabletron Systems Netlink FRX4000 User Manual

Configuring X.25
X.25 Port Parameters (screen 1 of 6)
* RLP: 0 Port: 5
* I/O: V.35
A Port Type
B Physical Port Interface
C Blocked Port Flag
D Line Speed
E Modulo
F Maximum LAPB Window Size
G N2 Retransmit Count
H T1 Retransmit Period (msec)
I T2 Wait Ack Period (msec)
J T3 Link Alive Period (sec)
K Logical DCE
L Generate Clock
M Rcv Clock (TT) from DTE
N X.25 Level 3 - Screen 2
Option:
On an FRX4000 port when
will be
CSU/DSU Operating Mode
After making any changes, be sure to press
system memory. Otherwise, the changes will not take effect until
the next re-boot of the FRX4000/6000.
Pressing at the screen in Figure 8-1 will display a second screen, and pressing
[N]
at the second screen will display a third screen. The parameters on all three screens are
listed in Table 8-1 (on page 8-6).
The third screen may be the last you need to configure for this port. At that screen:
If you want to configure one or more closed user groups, press
figuring Closed User
If this will be one end of a network trunk, press
Network Trunk" on page 8-5.)
If this port will be connected to a dial modem, press
Dial Port" on page 8-6.)
If none of the above applies, press
perform the next desired operation.
You cannot configure a port to be both a Network trunk and a Dial port.
Link State: Linkup
Database System Memory
X25 X25
V.35 V.35
N N
64k bps 64k bps
0 Modulo 8 0 Modulo 8
7 7
20 20
2000 2000
1000 1000
10 10
Y Y
Y Y
N N
Figure 8-1 X.25 Port Screen 1
Physical Port Interface
, and item M will be
Groups" on page 8-4)
twice to return to X.25 Port screen 1, then
[F3]
Node Name=nodexyz
from Main Menu
[A],[C],[A]
(item B) is
DSU
RTS Control
to update the
[F7]
. (See
[N]
. (See "Configuring a
[O]
. (See "Configuring a
[P]
, item L
.
[N]
"Con-
8-3