Cabletron Systems Netlink FRX4000 User Manual page 49

Introduction to Database Configuration
E Configure IP/LLC2/BRIDGE/IPX Default Parameters
A Configure IP Node Defaults
FRX4000/6000 will act as an IP gateway and which version of RIP
will be used.
B Configure Bridge/LLC-2 Node Defaults
parameters that will be used internally by the node to identify a
virtual bridge that will connect the LLC2 function to LAN
interfaces and frame relay PVCs.
C Review SNA LLC2 Hosts
(see below) that have been configured on the FRX4000/6000.
D Configure SNA LLC2 Hosts
the FRX4000/6000; includes session type (originated or
terminated), necessary addresses, timers.
E Configure IPX Node Defaults
the FRX4000/6000 when used as an interface to a Novell NetWare
network.
F Configure Filter Definitions and Applications
A Review IPX Filter Definitions
filters (see next item) that are configured on the FRX4000/6000.
B Configure IPX Filter Definitions
parameters for transmission of RIP and SAP updates, and/or
generic IPX packets, per interface and direction.
C Review IPX Filter Applications
information on any IPX filter applications (see below)
configured on the FRX4000/6000.
D Configure IPX Filter Applications
filters to interfaces/filter types/directions.
E On-Line Update IPX Filter Definitions and Applications
(Chapter 14) allows updating the FRX4000/6000 with any
changes without rebooting.
F Review Bridge Filter Definitions
Bridge filters (see next item) that have been configured on the
FRX4000/6000.
G Configure Bridge Filter Definitions
parameters for regulation of bridge traffic by filtering MAC
addresses, NetBIOS names, SAP updates, etc.
H Review Bridge Filter Applications
information on any bridge filter applications (see below)
configured on the FRX4000/6000.
I Configure Bridge Filter Applications
bridge filters to interfaces/filter types/directions.
J On-Line Update Bridge Filter Definitions and Applications
(Chapter 15) allows updating the FRX4000/6000 with any
changes without rebooting.
G On-Line Update Dynamic Routing Parameters
the system memory with any changes that have been made to
routing parameters.
F Configure Async PAD Parameters
parameters for devices connected to FRX4000/6000 async PAD ports.
A Review Async PAD Profiles
B Configure Async PAD Profiles
C Review Async PAD Logins
D Configure Async PAD Logins
– (Chapter 13) specifies whether the
– (Chapter 9) specifies
– (Chapter 9) displays any LLC2 hosts
– (Chapter 9) defines LLC2 hosts on
– (Chapter 14) defines operation of
– (Chapter 14) displays any IPX
– (Chapter 14) specifies
– (Chapter 14) displays
– (Chapter 14) applies IPX
– (Chapter 15) displays any
– (Chapter 15) specifies
– (Chapter 15) displays
– (Chapter 15) applies
– (misc.) updates
– (Chapter 12) defines operating
–
3-11