Sdlc Pu Subscriber Parameters Screen - Cabletron Systems Netlink FRX4000 User Manual

Configuring SNA
After entering a station address, a screen similar to the following will be displayed.
SDLC PU Subscriber Parameters (screen 1 of 2)
*RLP 1 Port 0
A PU Name
B Local Subscriber ID
C Remote Subscriber ID
D Maxdata (Max I-Frm bytes/frame)
E Autocall
F Autocall Retry Time
G Autocall Retry Count
H Istatus
I LPDA Resource ID
J LLC2 Connection
K Configure LLC2 Parameters
L L2 DatMode
Option:
Figure 9-3 SDLC PU Subscriber Parameters Screen
An SNA TPAD subscriber can specify only one remote device, which can
be an HPAD or an X.25 connection to the host. An HPAD subscriber can
specify up to 16 remote devices, any of which can be a TPAD or an X.25
connection to the host. An XPAD subscriber can specify only one remote
device, which must be another XPAD.
If SDLC/LLC2 conversion will be done on the PU connection, specify
in Figure 9-3, then press
(If the PU is not part of an SDLC/LLC2 connection, you do not have to configure
those parameters.)
Station Address C1
name
110001010100
100001000001
265
Y
60
0
Active
0
N
Two-way Alternate
to configure the LLC2 parameters (listed in
[K]
Node Name=nodexyz
for item J
[Y]
Table 9-2).
9-5