Configuring A Model Number - Cabletron Systems Netlink FRX4000 User Manual

Configuring a Model Number

16-6
Identification of the hardware chassis will is necessary if a network manager device
will access the node via SNMP. OmniView displays a graphic representation of the
configured chassis.
If the node will not be accessed by OmniView, configuration of a model
number is not necessary; however, configuring it now will avoid a problem
if OmniView is used at a later time.
To configure a model number, press
from the Main Menu). The currently configured model will be displayed. If the
[D], [D]
value needs to be changed, press
= FRX6000 Model 2
2
= FRX6000 Rackmount
3
= FRX4000
6
The Rackmount chassis is currently the only standard model of FRX6000;
however, Model 2 is supported for existing customers.
at the SNMP Configuration Menu (or
[D]
, then enter the correct value:
[A]
FRX4000/FRX6000 4.0 User Guide, Rev 01
[A], [A],