Configuring Bridge Filter Applications; Bridge Netbios Filter Parameters - Cabletron Systems Netlink FRX4000 User Manual

Filter Name
Source NetBIOS Name
Destination NetBIOS Name

Configuring Bridge Filter Applications

15-10
Table 15-6 Bridge NetBIOS Filter Parameters
Parameter
Filter Name
Source NetBIOS Name
Destination NetBIOS Name
helps the user identify the filter. The name is not used by the software.
should be obtained from a system administrator.
should be obtained from a system administrator.
Bridge Filter Applications determine how filters will be used at the interface. To
review existing applications, press
figuration Menu (or
[A], [A], [E], [F], [H]
cation, press at the Filter Definitions and Applications Configuration Menu. When
[I]
prompted, enter:
Bridge Port Number
interface.)
: = Generic
Filter Type 4
= Protocol
7
A MAC filter will be applied to LLC2 traffic whether or not bridging
is enabled (in Bridge Node Defaults). Other filter types will be
applied only if bridging is enabled.
: (inbound) or
Direction i
Any other requested information, referring to
Valid Values
1–31 characters
1–36 characters
1–36 characters
at the Filter Definitions and Applications Con-
[H]
from the Main Menu). To configure an appli-
: . (The default is
0–95 0
= MAC (Default)
5
= Bridged native NetBIOS.
8
(outbound). (The default is
o
Default Value
none
none
none
.) (This number simply identifies the
= LLC2 SAP
6
.)
o
Table 15-7.
FRX4000/FRX6000 4.0 User Guide, Rev 01