Introduction; Cli Commands Controlling Bootrom Access - 3Com 5500-SI Configuration Manual

A

Introduction

CLI Commands
Controlling Bootrom
Access
P
ASSWORD
The Switch 5500 has two separate password systems:
Passwords which are used by the Web User Interface and the CLI and are
n
stored in the 3comoscfg.cfg file.
For more information on this, refer to the Getting Started Guide which
accompanies your Switch.
A password system which protects the bootrom and is stored in the bootrom.
n
If the password protecting the bootrom is forgotten or lost, a fixed (unit
unique) password can be provided by 3Com Technical Support to bypass the
lost password.
This fixed password recovery mechanism can be disabled within the bootrom
menu. However, if the password recovery mechanism is disabled and the user
configurable bootrom password is lost, there is no recovery mechanism
available. In this instance, the Switch will need to be returned to 3Com for
repair.
The following commands are all executed from the Bootrom directly using the
console.
Access to the bootrom is enabled by default on your Switch.To disable access
enter the following command:
<5500-XX>undo startup bootrom-access enable
(where xx is either SI or EI)
If the bootrom is disabled, Ctrl-B is still available during the initial boot phase. The
only password that will be accepted at the prompt is the unit unique password.
any user configured bootrom password will be inactive.
The following commands enable and display the current bootrom access settings
respectively:
<5500-xx>startup bootrom-access enable
<5500-xx>display startup
R
ECOVERY
P
ROCESS