Assembling The Forward Gear; Assembling The Drive Shaft; Assembling The Oil Seal Housing; Installing The Shift Rod, Oil Seal Housing, And Drive Shaft - SELVA MARINE Kingfish 25 Service Manual

LOWR
TIP:
If a high-pitched metallic sound is produced
when the special service tool is struck, the
taper roller bearing outer race 0 is installed
properly.
6. Install the water inlet covers, and then
tighten the screw to the specified torque.
Water inlet cover screw:
1 N·m (0.1 kgf·m, 0.7 ft·lb)

Assembling the forward gear

Do not reuse a bearing, always replace it
with a new one.
1. Install a new taper roller bearing 1.
G
Bearing inner race attachment 2:
90890-06640

Assembling the drive shaft

Do not reuse a bearing, always replace it
with a new one.
1. Install a new taper roller bearing 1.
1
2
G
2
8-47
Lower unit
2
1
1
Bearing inner race attachment 2:
90890-06644

Assembling the oil seal housing

Do not reuse an oil seal or O-ring, always
replace it with a new one.
1. Install new oil seals 1 to the specified
depth a.
Driver rod LS 2: 90890-06606
Ball bearing attachment 3: 90890-06634
2
1
Depth a: 0–0.5 mm (0–0.02 in)
2. Install a new O-ring.
Installing the shift rod, oil seal
housing, and drive shaft
Do not reuse an O-ring, always replace it
with a new one.
1. Install the forward gear assembly 1.
2. Install the drive shaft assembly 2 and
pinion 3, and then tighten the nut 4 to
the specified torque.
2
A A
3
a
1