SELVA MARINE Kingfish 25 Service Manual page 366

Recommended PTT fluid: ATF Dexron II
8. Install a new O-ring 5 to the free piston
6, and then install the free piston 6 into
the cylinder 7.
7
9. Place the tilt cylinder end screw c at the
bottom of the tilt ram e.
10. Install the tilt ram assembly into the cylin-
der.
e
c
11. Tighten the tilt cylinder end screw c to
the specified torque.
8
c
6
5
Cylinder-end screw wrench 8:
90890-06568
Tilt cylinder end screw c:
90 N·m (9.0 kgf·m, 66.4 ft·lb)
12. Install the PTT motor. See "Installing the
PTT motor" (9-65).
Bleeding the PTT unit
Make sure that the tilt ram is fully extended.
1. Place the PTT unit in an upright position.
2. Close the manual valve 1 by turning it
counterclockwise.
PTT cylinder
9
9-76