Assembling The Forward Gear; Assembling The Drive Shaft Housing; Installing The Drive Shaft - SELVA MARINE Grey Whale 200 EFI Service Manual

NOTE:
• Apply gear oil to the needle bearing outer
case before installation.
• The needle bearing contains 24 rollers.
Ball bearing attachment 3:
90890-06655
Bearing outer race puller
assembly 4:
90890-06523

Assembling the forward gear

1. Install a new taper roller bearing into the
forward gear using a press.
Bearing inner race attachment 1:
90890-06659

Assembling the drive shaft housing

1. Install the needle bearing into the drive
shaft housing to the specified depth.
Needle bearing attachment 1:
90890-06610
Driver rod SS 2: 90890-06604
6AL3J11
Drive shaft and lower case (regular rotation model)
Depth a:
4.5 ± 0.25 mm (0.18 ± 0.01 in)
2. Apply grease to new oil seals, and then
install them into the drive shaft housing
to the specified depth.
4
NOTE:
Install an oil seal halfway into the drive shaft
housing, and then install the other oil seal.
Bearing outer race attachment 3:
90890-06628
Driver rod LS 4: 90890-06606
Depth b:
0.5 ± 0.25 mm (0.02 ± 0.01 in)

Installing the drive shaft

1. Install the forward gear into the lower
case.
b
3
A A
S6AL6090
1
2
3
4
5
6
7
8
9
6-16