Checking The Prime Start; Assembling The Carburetor - SELVA MARINE Kingfish 25 Service Manual

FUEL
a
Float height a:
14.0 ± 2.0 mm (0.55 ± 0.08 in)
TIP:
Take measurements at the float position
shown opposite the pivoting side.

Checking the Prime Start

1. Measure the length of the Prime Start
plunger before connecting the battery
leads.
Prime Start plunger length before battery
leads are connected (reference data):
10.7 mm (0.42 in)
2. Connect the special service tool 1.
3. Connect the battery leads, and then
measure the plunger length a.
1
G G/W
Test harness (2 pins): 90890-06867
6-13
Fuel system
1
a
Prime Start plunger length a after battery
leads are connected (reference data):
5 minutes: 14.2 mm (0.56 in)
10 minutes: 14.9 mm (0.59 in) at
23 °C (73 °F)

Assembling the carburetor

Do not reuse a gasket or O-ring, always
replace it with a new one.
1. Install the pilot jet 1, plug 2, main noz-
zle 3, and main jet 4.
4
3
2. Install the needle valve 5, float 6, float
pin 7, and screw 8.
6
c
b
TIP:
• Hook the needle valve 5 onto the tab a on
the float 6, and then fit the needle valve
into the valve seat b.
• Install the float pin 7 into the slots c in the
carburetor body, and then tighten the screw
8 to secure the pin.
2
1
a
7
5
8
c