Removing The Steering Arm; Installing The Steering Arm - SELVA MARINE Kingfish 25 Service Manual

Removing the steering arm

1. Remove the rubber seal 1.
2. Remove the steering arm 2, and then
remove the washer 3, bushing 4, and
friction piece 5.
3. Remove the bushing 6, O-ring 7, and
bushing 8.
2
3
4

Installing the steering arm

Do not reuse an O-ring or rubber seal,
always replace it with a new one.
1. Install the friction piece 1, bushing 2,
and washer 3, and then install the steer-
ing arm 4.
2. Install the bushing 5, a new O-ring 6,
and the bushing 7.
3. Install a new rubber seal 8, and then
tighten the friction piece bolt 9 to the
specified torque.
4
3
5
A A
2
1
Friction piece bolt 9:
3.9 N·m (0.39 kgf·m, 2.88 ft·lb)
4. Inject grease into the grease nipple on
8
the swivel bracket. See "Lubricating the
outboard motor" (10-14).
7
6
Steering arm
A A
1
8
9
5
6
A A
7
9-42
9