Shifting; Forward (Tiller Handle And Remote Control Models); Reverse (Automatic Reverse Lock And Power Trim And Tilt Models); Stopping Engine - SELVA MARINE MARLIN 100 EFI Owner's Manual

EMU27740

Shifting

EWM00180
WARNING
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
ECM00220
CAUTION:
To change the boat direction or shifting
position from forward to reverse or vice-
versa, first close the throttle so that the en-
gine idles (or runs at low speeds).
EMU27763
Forward (tiller handle and remote
control models)
Tiller control models
1. Place the throttle grip in the fully closed
position.
2. Move the gear shift lever quickly and firm-
ly from neutral to forward.
Remote control models
Pull up the neutral interlock trigger (if
equipped) and move the remote control lever
quickly and firmly from neutral to forward.
EMU27784
Reverse (automatic reverse lock and
power trim and tilt models)
EWM00190
WARNING
When operating in reverse, go slowly. Do
not open the throttle more than half. Other-
wise the boat could become unstable,
which could result in loss of control and
an accident.
Tiller control models
1. Place the throttle grip in the fully closed
position.
2. Move the gear shift lever quickly and firm-
ly from neutral to reverse.
Remote control models
Pull up the neutral interlock trigger (if
equipped) and move the remote control lever
quickly and firmly from neutral to reverse.
EMU27820

Stopping engine

Before stopping the engine, first let it cool off
for a few minutes at idle or low speed. Stop-
ping the engine immediately after operating at
high speed is not recommended.
EMU27844

Procedure

1. Push and hold the engine stop button or
turn the main switch to "
Operation
" (off).
24