SELVA MARINE Kingfish 25 Service Manual page 264

Driver rod LL 1: 90890-06605
Bearing outer race attachment 3:
90890-06622
TIP:
If a high-pitched metallic sound is produced
when the special service tool is struck, the
taper roller bearing outer race 2 is installed
properly.
3. Install a new needle bearing 4 to the
specified depth a.
5
6
c
a
7
G
Driver rod SL 5: 90890-06602
Bearing depth plate 6: 90890-06603
Needle bearing attachment 7:
90890-06614
Depth a: 182.5–183.0 mm (7.19–7.20 in)
TIP:
• Face the identification mark b on the nee-
dle bearing toward the water pump side.
• Install the stopper c onto the driver rod 5
at the specified depth a. Install the needle
bearing until the stopper c contacts the
special service tool 6.
Drive shaft and lower case (high thrust model)
4. Heat the installation area of the taper
roller bearing outer race in the lower
case using a gas torch, and then install
the sleeve 8, the original pinion shims
9, and a new taper roller bearing outer
race 0. NOTICE: When heating the
lower case, heat the entire installation
area evenly. Otherwise, the paint on
the lower case could be burned.
b
7
TIP:
4 • Make sure to install the sleeve 8 with the
protrusion d facing forward.
• Do not reuse a shim if deformed or
scratched.
5. While holding the special service tool A,
strike the tool to check that the taper
roller bearing outer race 0 is installed
properly.
A
B
Driver rod LS A: 90890-06606
Bearing outer race attachment B:
90890-06627
0
9
G
8
d
8
B
0
8-46