SELVA MARINE Kingfish 25 Service Manual page 367

BRKT
3. Remove the reservoir cap 2, and then
check the fluid level in the reservoir.
2
Recommended PTT fluid: ATF Dexron II
TIP:
• If the fluid is at the proper level, a small
amount of fluid should flow out of the filler
hole.
• If the fluid is below the proper level, add the
recommended PTT fluid up to the proper
level.
4. Install the reservoir cap 2, and then
tighten it to the specified torque.
Reservoir cap 2:
7 N·m (0.7 kgf·m, 5.2 ft·lb)
5. Connect the PTT motor leads to the bat-
tery terminals to fully retract the tilt ram.
9-77
Bracket unit
1
Ram PTT motor lead
Green (G)
Down
Blue (L)
6. Reverse the PTT motor lead connections
between the battery terminals to fully
extend the tilt ram.
Ram PTT motor lead
Blue (L)
Up
Green (G)
TIP:
If the tilt ram does not move up and down
easily, push and pull on the ram to assist the
operation.
L
G
Battery
terminal
+
-
G
L
Battery
terminal
+
-