Replacing The Oil Filter; Checking The Engine Start Button Or Switch And Engine Shut-Off Switch; Checking The Fuel Filter; Checking The Fuel Joint And Fuel Hose (Fuel Joint To Carburetor) - SELVA MARINE Kingfish 25 Service Manual

Replacing the oil filter

1. Extract the engine oil using an oil
changer. See steps 1–4 in "Changing the
engine oil" (10-10).
2. Place a rag under the oil filter, and then
remove the oil filter.
Oil filter wrench 1: 90890-01426
TIP:
Make sure to clean up any oil spills.
3. Install the oil filter, and then tighten it to
the specified torque.
1
E
Oil filter: 18 N·m (1.8 kgf·m, 13.3 ft·lb)
4. Fill the engine with the specified amount
of the recommended engine oil through
the oil filler hole.
Recommended engine oil:
4-stroke motor oil with combinations of
the following SAE and API oil classifica-
tions:
API: SE, SF, SG, SH, SJ, SL
SAE: 5W-30, 10W-30, 10W-40
Replacement engine oil quantity:
With oil filter replacement:
1.6 L (1.69 US qt, 1.41 Imp qt)
5. Install the oil filler cap and oil dipstick,
and then start the engine and warm it up
for 5 minutes.
1
6. Stop the engine, and then leave it off for
5–10 minutes.
7. Check the oil level. If the oil level is low,
add engine oil up to the proper level.
Checking the engine start button or
switch and engine shut-off switch
1. Check the engine start button or switch
and engine shut-off switch. See "Check-
ing the engine start button or switch and
engine shut-off switch" (10-4).

Checking the fuel filter

1. Check the fuel filter. See "Checking the
fuel filter assembly" (6-4).
Checking the fuel joint and fuel hose
(fuel joint to carburetor)
1. Check the fuel joint and fuel hose con-
nections. See "Fuel hose, blowby hose,
and cooling water hose" (6-1).

Changing the gear oil

Never get under the lower unit while it is
tilted.
1. Tilt the outboard motor so that the drain
screw is at the lowest point.
2. Place a drain pan 1 under the gear oil
drain hole.
General periodic maintenance
10
10-12