SELVA MARINE Kingfish 25 Service Manual page 213

POWR
A
k
Connecting rod bolt A:
1st: 6 N·m (0.6 kgf·m, 4.4 ft·lb)
2nd: 17 N·m (1.7 kgf·m, 12.5 ft·lb)
TIP:
• Make sure that the protrusions r on the
connecting rod and connecting rod cap k
face towards the flywheel magnet end of
the crankshaft.
• Make sure that the crankshaft turns
smoothly.
9. Install the crankshaft journal bearings B.
10. Apply a thin, even layer of sealant onto
the mating surface of the crankcase C.
C
E
7-65
Power unit
E
r
E
518
B
B
TIP:
• Install the crankshaft journal bearings B in
the original positions.
• Do not apply any sealant on the crankshaft
journal bearings.
11. Install the crankcase C, and then tighten
the bolts D to the specified torques in 2
stages and in the order 1, 2, and so on.
12. Tighten the bolts E to the specified
torques in 2 stages and in the order 7,
8, and so on.
E
E C
E
5
E
9
1
8
4
B
D
6
D
0
2
7
3
A