SELVA MARINE Kingfish 25 Service Manual page 173

POWR
4
Crankshaft holder 5: 90890-06355
Drive sprocket nut 4:
150 N·m (15.0 kgf·m, 110.6 ft·lb)
2. Install the dowel 6, driven sprocket 7,
and washer 8, and then tighten the bolt
9 to the specified torque.
E
9
0
Flywheel holder 0: 90890-06522
Driven sprocket bolt 9:
38 N·m (3.8 kgf·m, 28.0 ft·lb)
7-25
Power unit
5
5
9
8
7
6
3. Align the notch a in the drive sprocket 2
with the protrusion b on the cylinder
block.
4. Align the "1" mark c on the driven
sprocket 7 with the " " mark d on the
cylinder head.
5. Install the timing belt A onto the drive
sprocket 2, and then install it onto the
driven sprocket 7 so that the part num-
ber e is in the upright position. NOTICE:
Do not apply grease or oil to the tim-
ing belt.
A
2
6. Turn the crankshaft clockwise 2 full turns
until the notch a in the drive sprocket 2
is aligned with the protrusion b on the
cylinder block. Check that the "1" mark c
on the driven sprocket 7 is aligned with
the " " mark d on the cylinder head.
2
b
a
7
c
d
e
7