SELVA MARINE Kingfish 25 Service Manual page 210

a
TIP:
Do not place the Plastigauge (PG-1) over the
oil hole in each crankshaft journal.
5. Install the crankshaft journal bearings
into the crankcase.
TIP:
Install the crankshaft journal bearings in the
original positions.
6. Install the crankcase 4, and then tighten
the bolts 5 to the specified torques in 2
stages and in the order 1, 2, and so on.
7. Tighten the bolts 6 to the specified
torques in 2 stages and in the order 7,
8, and so on.
E
4
6
E
6
9
1
8
4
B
Crankcase bolt 5 1–6 (M8):
1st: 15 N·m (1.5 kgf·m, 11.1 ft·lb)
2nd: 30 N·m (3.0 kgf·m, 22.1 ft·lb)
Crankcase bolt 6 7–B (M6):
1st: 6 N·m (0.6 kgf·m, 4.4 ft·lb)
2nd: 12 N·m (1.2 kgf·m, 8.9 ft·lb)
TIP:
Do not turn the crankshaft until the crankshaft
journal oil clearance measurement has been
completed.
8. Remove the crankcase, and then mea-
sure the width of the compressed Plasti-
gauge
5
journal.
Crankshaft journal oil clearance
(reference data):
0.012–0.036 mm (0.0005–0.0014 in)
Cylinder block
5 6
5
(PG-1) on each crankshaft
0
2
7
3
A
7
7-62