SELVA MARINE Kingfish 25 Service Manual page 76

g
h
k
C/L
C/L: Centerline of transom
Drilling plate 1: 90890-06783
Mounting hole diameter k:
10.5 mm (0.4 in)
13.0 mm (0.5 in)
5. Apply sealant to the mounting holes and
secure the outboard motor using the
included mounting bolts 2, small wash-
ers 3, large washers 4, and nuts 5.
NOTICE: Make sure that there is no
clearance between the surfaces of the
boat transom and the clamp brackets.
Otherwise, the clamp brackets or boat
transom may be damaged.
1
(H)
g
Mounting the outboard motor
2
3
5
4
3
SS
2
3
Boat transom
thickness (D)
55–65 mm
(2.17–2.56 in)
TIP:
The second hole from the top of each clamp
bracket is recommended for the upper
mounting bolt. (PTT model)
6. Install the mounting bolts, and then
tighten the nuts firmly. NOTICE: Make
sure that the clamp brackets do not
bite into the boat transom.
7. Tighten the locknuts firmly.
2
3
4
3
5
4
3
5
Mounting bolt
M10 × 100 mm
(3.94 in)
M12 × 105 mm
(4.13 in)
3-12
3