Removing The Flywheel Magnet; Removing The Timing Belt And Sprocket - SELVA MARINE Kingfish 25 Service Manual

POWR

Removing the flywheel magnet

Do not turn the flywheel magnet counter-
clockwise. Otherwise, the water pump
impeller could be damaged.
1. Remove the manual starter and driven
sprocket cover. See "Removing the man-
ual starter" (7-7). (Manual starter model)
Remove the flywheel magnet cover and
driven sprocket cover. (Electric starter
model)
2. Loosen the nut. NOTICE: Apply force in
the direction of the arrow to prevent
the flywheel holder 1 from slipping
off easily.
Flywheel holder 1: 90890-06522
3. Remove the flywheel magnet and Woo-
druff key. NOTICE: To prevent damage
to the engine or tools, screw in the
puller set bolts evenly and completely
so that the flywheel puller is parallel
to the flywheel magnet.
2
Flywheel puller 2: 90890-06521
7-23
Power unit
1
4. Remove the pulser coil 3, and then
remove the stator assembly 4 and base
5.
4
3
5
Removing the timing belt and
sprocket
Do not turn the drive sprocket or driven
sprocket when the timing belt is not
installed. Otherwise, the pistons and
valves could collide with each other and
be damaged.
1. Align the "1" mark a on the driven
sprocket 1 with the " " mark b on the
cylinder head.
2. Check that the notch c in the drive
sprocket 2 is aligned with the protrusion
d on the cylinder block.
1
a
b
2
c
d