Table of Contents
Advertisement
Default Settings & Facts
The following lists the default settings of your NetComm Cable/DSL Firewall Router.
Note: It is highly recommended that you enable security settings in the router before
connecting your router to your network.
Router
LAN IP:
Username:
Password:
WAN port MDI:
Resetting
While using or installing your NetComm Cable/DSL Firewall Router you may need to utilise the
reset feature. There are two types of reset:
Soft
A soft reset will restart the unit and reconnect to the internet using the settings stored
previously, none of your settings are deleted. To perform a soft reset briefly press the reset
button on the back of the unit.
Hard
A hard reset will return your unit to its factory default setting, meaning that you will loose
all configurations and logs set/stored previously. To perform a hard reset, press and hold in
the reset button on the back of the unit for 10 seconds.
Power
Ensure that you only use the Power Adaptor supplied (5V DC, 3amps, Center pole positive)
with your NetComm Cable/DSL Firewall Router.
Rev.2 - YML630
Cable/DSL Firewall Router
192.168.1.1
<none>
admin
Auto MDI (No cross over cable required)
www.netcomm.com.au
Page 3
Advertisement
Table of Contents
