Table of Contents
Advertisement
In order to access the Internet through the router, each host on your network must install/setup
TCP/IP. Please follow the steps below for select a network adapter.
Setting TCP/IP on Client PC
To access the ADSL Router via Ethernet, the host computer must meet the following requirements:
With Ethernet network interface.
Must have TCP/IP installed.
Set client PC with obtain an IP address automatically or set fix
With a web browser installed: Internet Explorer 5.x or later.
The ADSL Router is configured with the default IP address of 10.0.0.138 and subnet mask
of 255.255.255.0. As the DHCP server is Enable by default, The DHCP clients should
to access the ADS
L Router. Or you could assign an IP address to the host PC first for initial
configuration.
You also can manage the ADSL Router through a web browser-based manager: ADSL ROUTER
CONTROL PANEL. The ADSL Router man
allow you to set up and manage the device.
To configure the device via web browser, at least one properly-configured PC must be connected
the netwo
rk (either connected directly or through an external hub/switch to the LAN port of the
device).
If TCP/IP is not already installed, follow the steps below for installation.
Chapter 3:Configuration
Configuration
ager uses the HTTP protocol via a web browser to
Chapter 3
IP address.
be able
to
5
Advertisement
Table of Contents
