Table of Contents
Advertisement
Configuring a Service
Profile
Disabling or Reenabling Automatic Firmware Upgrades
A MAP can automatically upgrade its boot firmware by loading the
upgrade version of the firmware from a WX switch when the MAP is
booting. Automatic firmware upgrades are enabled by default.
To disable or reenable automatic firmware upgrades, use the following
command:
{
ap port-list | dap dap-num}
set
upgrade-firmware
Enabling LED Blink Mode
When blink mode is enabled on an AP2750, the 11a LED blinks on and
off.
When blink mode is enabled on an AP7250, the Radio LED flashes red
and the Power LED flashes green/orange. The Ethernet LED does not
change.
When blink mode is enabled on an AP8250, the Radio LED flashes red
and the Power LED flashes green/orange. The Ethernet LED does not
change.
When blink mode is enabled on an AP8750, both Radio LEDs flash red
and the Power LED flashes green/orange. The Ethernet LED does not
change.
When blink mode is enabled on other models (MP-xxx), the health and
radio LEDs alternately blink green and amber. By default, blink mode is
disabled.
Changing the LED blink mode does not alter operation of the MAP access
point. Only the behavior of the LEDs is affected.
To enable or disable LED blink mode, use the following command:
{
ap port-list | dap dap-num} blink {enable | disable}
set
A service profile is a set of parameters that control advertisement
(beaconing) and encryption for an SSID.
This section describes how to create a service profile and set SSID
parameters. To configure encryption parameters, see Chapter 7,
"Configuring User Encryption," on page 165.
Configuring MAP Access Points
{
|
enable
disable
}
145
Advertisement
Table of Contents
