Ip Protocol; Source And Destination Ip Address - Avaya W310 User Manual

IP Protocol

To specify which the IP protocol to which the rule applies, use the
followed by the name of an IP protocol. If you want the rule to apply to all protocol, use
with the command. If you want the rule to apply to all protocols except for one, use the no
form of the command, followed by the name of the protocol to which you do not want the
rule to apply.
• The following command specifies the UDP protocol for rule 1 in QoS list 401:
W310-1(QoS 401/rule 1)# ip-protocol udp
• The following command specifies any IP protocol except IGMP for rule 3 in access
control list 302:
W310-1(ACL 302/ip rule 3)# not ip-protocol igmp

Source and Destination IP Address

To specify a range of source and destination IP addresses to which the rule applies, use the
commands
criteria can be any of the following:
• a range — type two IP addresses to set a range of IP addresses to which the rule applies
• a single address — type
which the rule applies.
• wildcard — type
addresses to which the rule applies
• any — type
Avaya W310 User's Guide
and
source-ip destination-ip
, followed by an IP address, to set a single IP address to
host
, followed by an IP address using wildcards, to set a range of IP
host
to apply the rule to all IP addresses
any
, followed by the IP range criteria. The IP range
Configuring Policy
command,
ip-protocol
any
251