D/A Standby Control Register (Dastcr) - Renesas F-ZTAT H8 Series Hardware Manual

Section 16 D/A Converter
16.2.3

D/A Standby Control Register (DASTCR)

DASTCR is an 8-bit readable/writable register that enables or disables D/A output in software
standby mode.
Bit 7
—
Initial value 1
Read/Write —
DASTCR is initialized to H'FE by a reset and in hardware standby mode. It is not initialized in
software standby mode.
Bits 7 to 1—Reserved: Read-only bits, always read as 1.
Bit 0—D/A Standby Enable (DASTE): Enables or disables D/A output in software standby
mode.
Bit 0: DASTE Description
0 D/A output is disabled in software standby mode
1 D/A output is enabled in software standby mode
Rev. 7.00 Sep 21, 2005 page 562 of 878
REJ09B0259-0700
6 5 4
— — —
1 1 1
— — —
Reserved bits
3 2 1
— — —
1 1 1
— — —
D/A standby enable
Enables or disables D/A output
in software standby mode
0
DASTE
0
R/W
(Initial value)