14.1
Overview
As an extension of its serial communication interface functions, SCI0 supports a smart card (IC
card) interface conforming to the ISO/IEC7816-3 (Identification Card) standard. Switchover
between normal serial communication and the smart card interface is controlled by a register
setting.
14.1.1
Features
Features of the smart-card interface supported by the H8/3048 Group are listed below.
• Asynchronous communication
Data length: 8 bits
Parity bits generated and checked
Error signal output in receive mode (parity error)
Error signal detect and automatic data retransmit in transmit mode
Supports both direct convention and inverse convention
• Built-in baud rate generator with selectable bit rates
• Three types of interrupts
Transmit-data-empty, receive-data-full, and receive-error interrupts are requested
independently. The transmit-data-empty and receive-data-full interrupts can activate the DMA
controller (DMAC) to transfer data.
Section 14 Smart Card Interface
Section 14 Smart Card Interface
Rev. 7.00 Sep 21, 2005 page 509 of 878
REJ09B0259-0700