Scan Mode (Scan = 1) - Renesas F-ZTAT H8 Series Hardware Manual

Section 15 A/D Converter
15.4.2

Scan Mode (SCAN = 1)

Scan mode is useful for monitoring analog inputs in a group of one or more channels. When the
ADST bit is set to 1 by software or external trigger input, A/D conversion starts on the first
channel in the group (AN
selected, after conversion of the first channel ends, conversion of the second channel (AN
AN ) starts immediately. A/D conversion continues cyclically on the selected channels until the
5
ADST bit is cleared to 0. The conversion results are transferred for storage into the A/D data
registers corresponding to the channels.
When the mode or analog input channel selection must be changed during analog conversion, to
prevent incorrect operation, first clear the ADST bit to 0 in ADCSR to halt A/D conversion. After
making the necessary changes, set the ADST bit to 1. A/D conversion will start again from the
first channel in the group. The ADST bit can be set at the same time as the mode or channel
selection is changed.
Typical operations when three channels in group 0 (AN
described next. Figure 15.4 shows a timing diagram for this example.
1. Scan mode is selected (SCAN = 1), scan group 0 is selected (CH2 = 0), analog input channels
AN to AN are selected (CH1 = 1, CH0 = 0), and A/D conversion is started (ADST = 1).
0 2
2. When A/D conversion of the first channel (AN
ADDRA. Next, conversion of the second channel (AN
3. Conversion proceeds in the same way through the third channel (AN
4. When conversion of all selected channels (AN
and conversion of the first channel (AN
interrupt is requested at this time.
5. Steps 2 to 4 are repeated as long as the ADST bit remains set to 1. When the ADST bit is
cleared to 0, A/D conversion stops. After that, if the ADST bit is set to 1, A/D conversion
starts again from the first channel (AN
Rev. 7.00 Sep 21, 2005 page 546 of 878
REJ09B0259-0700
when CH2 = 0, AN
0 4
) starts again. If the ADIE bit is set to 1, an ADI
0
).
0
when CH2 = 1). When two or more channels are
to AN ) are selected in scan mode are
0 2
) is completed, the result is transferred into
0
) starts automatically.
1
to AN ) is completed, the ADF flag is set to 1
0 2
or
1
).
2