Table of Contents
Advertisement
Figure 6.17-4 Slave mode Interface Block Diagram
2
6.17.5.3 I
S Operation
2
The I
S controller supports MSB-justified, LSB-justified, and I
I2S_LRCLK signal indicates which audio channel is in transferring. The bit count of an audio
channel is defined by CHWIDTH (I2S_CTL0[29:28]), and the bit-width of data word in an audio
channel is determined by DATWIDTH (I2S_CTL0[5:4]). If CHWIDTH (I2S_CTL0[29:28]) is less than
DATWIDTH (I2S_CTL0[5:4]), the hardware will set the channel bit-width to be same as data bit-
width. However, there will be redundant zero bits in each audio channel if CHWIDTH
(I2S_CTL0[29:28]) is greater than DATWIDTH (I2S_CTL0[5:4]).
I2S_BCLK
I2S_LRCLK
I2S_DI /
I2S_DO
Figure 6.17-5 I
I2S_BCLK
I2S_LRCLK
I2S_DI /
I2S_DO
Figure 6.17-6 I
The transferring data sequence is always started from the MSB (most significance bit) to the LSB
(least significance bit). As the Figure 6.17-7, transmitting data are read at rising edge of I2S_BCLK
and sent out at falling edge of I2S_BCLK in I
latched at the next falling edge of I2S_BCLK cycle after the transition of I2S_LRCLK. In MSB
justified data format, the I2S_LRCLK changes the polarity at the transmitting of the first data bit
(MSB) in each audio channel. In LSB justified data format, the LSB is sent and latched at the last
Sep 9, 2019
ISD94100 Series Technical Reference Manual
I2S_MCLK
IS2_BCLK
2
I2S_LRCLK
I
S
Slave
I2S_DO
I2S_DI
Data Word
Channel width
Left channel of frame N
2
S Channel Width and Data Width (CHWIDTH≦DATWIDTH)
Redundant
Data Word
zero pad
Data width
Channel width
2
S Channel Width and Data Width (CHWIDTH > DATWIDTH)
2
S protocol. In I
Page 804 of 928
Master
2
S Philips standard data format. The
Data Word
Channel width
Right channel of frame N
Redundant
Data Word
zero pad
Data width
Channel width
2
S data format, the MSB is sent and
Data Word
Frame N+1
Data Word
Rev1.09
Hide quick links:
Advertisement
Table of Contents
