This mode does not support IAP -- because it cannot access APROM, and the LDROM has only 4
KB – one page size. In this mode remapping is not supported.
6.4.4.2.4
Boot from APROM without IAP support
By writing 0b11 into CBS[1:0] bits in CONFIG0, the ISD94100 device will load the system vector
table from APROM space 0x0000_0000 - 0x0000_01FF. In this mode the MCU boots from
APROM. And the MCU can only the access APROM, and data Flash if the partition for data flash
exists, as shown in Figure 6.4-7.
Sep 9, 2019
ISD94100 Series Technical Reference Manual
0x0010_0FFF
0x0010_0200
0x0010_01FF
0x0010_0000
0x0007_FFFF
0x0000_0200
0x0000_01FF
System Vector Table
0x0000_0000
Figure 6.4-6 Boot from LDROM without IAP support
Reserved
0x0010_0FFF
Reserved
0x0010_0000
Reserved
Data Flash
0x0007_FFFF
DFBA
ApplicationROM
(APROM)
0x0000_0200
0x0000_01FF
System Vector Table
0x0000_0000
Figure 6.4-7 Boot from APROM without IAP support
Page 198 of 928
Reserved
Loader ROM
(LDROM 4KB)
Vector Table
Reserved
Reserved
Mapping to
Rev1.09