Xerox WorkCentre 5790 Series Service Manual page 284

08-174 Missing Pre-release Sheet RAP
08-174 The IOT detected a missing pre-release sheet.
Initial Actions
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
• Enter the machine status mode and check for the active messages. Refer to
Codes and Message RAP for the jam clearance procedure.
• Check the condition of the paper in all trays. Refer to
• Check for obstructions in the registration paper path.
• Make sure that all covers and paper guides are closed, and latch correctly.
Procedure
If the initial actions did not resolve the problem. Switch off the machine, then switch on the
machine, GP 14. If a fault code is displayed then go to the appropriate RAP.
Status Indicator RAPs
08-174, 08-180
WARNING
IQ1 and GP 20.
08-180 Unable to Feed Next Sheet RAP
08-180 The machine has detected that the previous sheet has not correctly fed through the
paper path.
Initial Actions
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
death or injury. Moving parts can cause injury.
OF4 Status
• Clear the paper path.
Procedure
35-55 ppm - Perform the following:
• Check tray 1 feed sensor, Q80-101. Refer to
Install new components as necessary.
• Check tray 2 feed sensor, Q08-102. Refer to
Install new components as necessary.
• Check the registration sensor, Q08-150 and the wait sensor, Q08-100, refer to
08-151A Registration Jam RAP (35-55 ppm).
Install new components as necessary.
65-90 ppm - Perform the following:
• Check tray 1 feed sensor, Q80-101. Refer to
Install new components as necessary.
• Check tray 2 feed sensor, Q08-102. Refer to
Install new components as necessary.
• Check the registration sensor, Q08-150 and the wait sensor, Q08-100, refer to
08-151B Registration Jam RAP (65-90 ppm).
Install new components as necessary.
May 2013
2-252
WARNING
GP 14. Disconnect the power cord. Electricity can cause
08-101 Tray 1 Misfeed RAP.
08-102 Tray 2 Misfeed RAP.
08-101 Tray 1 Misfeed RAP.
08-102 Tray 2 Misfeed RAP.
Xerox® WorkCentre® 5790 Family
08-150A,
08-150B,