[5]
Remove the 3 BOLTS and WASHERS that hold the BLOWER MOTOR.
[6]
Move the BLOWER MOTOR to the 50 Hz position.
[7]
Install, but do not tighten the 3 BOLTS and WASHERS.
It is not necessary to loosen the SETSCREWS on the PULLEY. If the SETSCREWS are
loosened, use SEALANT TL-2390 on the SETSCREWS.
[8]
Move the BELT from the small PULLEY to the large PULLEY.
30
BELT
60 Hz (Factory Set)
Figure 35 Moving the Blower Motor to the 50 Hz Position
IMPORTANT
BLOWER MOTOR
BOLT (3)
WASHER (3)
BELT
BOLT (3)
WASHER (3)
50 Hz
H108_0358BCB
H108_0358BA
1C0932