Suzuki Wagon R Manual page 102

FRONT END ALIGNMENT 3A-3
STEERING ANGLE
When tie rod or tie rod end was replaced, check toe and then also
steering angle with turning radius gauge.
If steering angle is not correct, check if right and left tie rods are
equal in length ("A" in left figure).
NOTE:
If tie rod lengths were changed to adjust steering angle, rein-
spect toe-in.
Steering angle inside : 35 ± 3_
Turning radius gauge
outside: 31 ± 3_
Reference Information:
Side slip:
For inspecting front wheel side slip with side slip tester:
Side slip limit: IN 2 mm/m – OUT 4 mm/m
(IN 0.079 in/3.3 ft – OUT 0.157 in/3.3 ft)
If side slip exceeds above limit, toe-in or front wheel alignment may
not be correct.